Back wallFloor
Carpet colours (L-series)
Sangetsu punch carpet (S-series)
Logo LED colour
Design A · build guide ▾
#PartQtyWeight
1Top row: panels cut to 75 cm, clicked together with their own connectors7 of 10~4.4 kg*
2Under the wood: 3 panels laid sideways (40 cm tall), then the 7 top offcuts (45 cm) below3 of 10~4.2 kg*
3Side pieces 51×60 cm beside the wood (each: 40×60 from an extra panel + 11×60 strip from the offcut) + loose leaves2~0.2 kg*
4Short straps with hooks on the plant top edge, over the top pole50.2 kg
5Wood: pre-cut strip panels, 44.5×60 cm (8 bought: these 4 on the wall)43.0 kg
6LED letters on studs, bolted through the board1 set~4 kg*
7Straps with hooks for the wood: 2 per panel10~0.3 kg
8LED driver + cable to outlet1~0.5 kg*
9Black fabric cap 320×60 cm + clips10.5 kg
11Suitcase 1: 8 plant panels rolled, 4 per layer~8 kg*
12Suitcase 2: 5 wood panels + foam, 2 plant rolls, bag of driver/cables/straps, leaves + fabric~12 kg*
Total on the crossbar~18 kg

Your suitcases: 65 × 45 cm inside. Wood is 8 pre-cut panels of 44.5 × 60 cm, laid flat. Plants travel uncut as full rolls (cut them at the booth). LED letters go in a carry-on.

* estimate: ask the seller for exact weights. Wood: 5 × 0.75 kg per panel on the wall.

  1. At home: fix 2 straps with hooks to the top of the 5 wall panels. The other 3 go on the front and end of the table.
  2. At home: drill the letter stud holes between strips using the paper template; test-fit, then pack the letters separately.
  3. Roll the 10 panels uncut (they fit the 41 cm inside width). At the booth: cut 7 to 75 cm (keep the 45 cm offcuts), 1 to 40 cm, and two 51 × 60 cm side pieces (40 cm from an extra panel + an 11 cm strip from the offcut).
  4. Booth: lay the panels face down and click them together with their own connectors into one mat, leaving the gap for the wood.
  5. Fix 5 short straps with hooks along the top edge.
  6. Turn the mat over, lift it and hook the 5 straps over the top pole.
  7. Hang the 5 wood panels in the gap, each on its own 2 straps over the pole.
  8. Tuck loose leaves round the wood edges. Screw the letters on, tape the LED driver behind, run the cable down to the outlet.
  9. Last: black fabric over the top pole and down both sides. Switch on.

Everything (~21 kg) now hangs from the crossbar. Ask Freeman what it can hold; if it is less, let the bottom mat touch the floor so it carries its own ~6 kg.

A · Wood strips
A3 · Full width
A2 · Horizontal
B · Plants only
C · DCM panels
D · Plain board
E · Zen garden
F · Forest clearing
Drag to rotate · hold Space + drag to move · scroll or pinch to zoom · double-click to re-centre